Laboratory Unit - An enclosed space used for experiments or tests. The Hazard Identification System is not intended to identify the non emergency health hazards of chemicals. NFPA 704, Standard System for the Identification of the Fire Hazards of Materials, provides planning guidance to fire departments for safe tactical procedures in emergency operations, and gives on-the-spot information to safeguard the lives of fire fighting personnel and the others who may be exposed. *NFPA is the acronym for the National Fire Protection Association. This data have been tabulated for easier reading. ClassIIIB - Flash Point: At or Above 200 degrees F.ClassIIIA - Flash Points: At or Above 140 degrees F and below 200 degrees F.ClassII - Flash Points: At or Above 100 degrees F and below 140 degrees F.Combustible liquids are subdivided as follows: "Combustible liquids" refers to any liquid having a flash point at or above 100F. ClassIC - Flash Point: At or Above 73 degrees F, Boiling Point: Below 100F.ClassIB - Flash Point: Below 73 degrees F, Boiling Point: At or Above 100F.ClassIA - Flash Point: Below 73 degrees F, Boiling Point: Below 100F. The following is an illustrative list of common flammable liquids. These liquids are subdivided into three classes. "Flammable liquid" refers to any liquid having a flashing point below 100F. Keefe Campus Center Fire Pit Procedures.Fire Detection and Suppression System Impairment Policy.Fire Detection and Suppression Guidelines.Fire Alarm and Sprinkler Systems Work Permit.Construction and General Industry Safety.Under safety aspects the flash point is in comparison to the firing point of far greater importance or relevance, since it defines the lowest temperature where at the inflammation of an explosive gas / air mixtures is possible. The ignition point (also ignition temperature, spontaneous ignition temperature) defines the temperature to which one has to heat a substance or a contact surface, so that a combustible substance (solids, liquids, their vapor or gas) in the presence of air exclusively on the basis of its own temperature self-ignites - without an ignition source such as a spark. Flash and firing point have to be distinguished from the ignition point. From this temperature, a permanent combustion is possible even after removal of the ignition source, because the substance surface then delivers flammable vapors in sufficient quantity. The inflowing from the fuel vapor amount is also not sufficient to allow a permanent combustion.Īt the same gas pressure, a few degrees above the flash point, is the firing point. Because the resulting heat of combustion is not sufficient to heat the liquid until it reaches the focal point, the combustion at the flash point comes back to a standstill even when the ignition source is not removed. The flash point is the lowest temperature at which a liquid under specified test conditions gives off flammable gas or flammable vapor in such an amount that upon contact with an effective ignition source immediately a flame occurs. What is the difference between flash point, firing point and ignition point?
0 Comments
Leave a Reply. |